1 (866) 313-2180
SALES@FORKLIFTTIRE.COM20x8x16 Cushion & Polyurethane Press-On Forklift Tires
The 20x8x16 cushion press-on tire is a drive tire used on the rear axle of electric and LP forklift models. Available in both rubber cushion and polyurethane compounds, this size fits a 16" press-on hub and is pressed onto the wheel using a hydraulic press.
20x8x16 Tire Specifications
- Overall Diameter: 20 inches
- Section Width: 8 inches
- Wheel Fitment: 16-inch press-on hub
- Steel Press-On Ring: ~3/8" bonded band (industry standard)
- Installation: Requires hydraulic press equipment
Rubber Cushion vs Polyurethane
Rubber cushion tires are the standard choice for most indoor applications. They provide a smooth ride on concrete and warehouse floors, resist cuts and chunking under normal load cycles, and are widely available at lower cost. Polyurethane press-on tires are a non-marking alternative that offers significantly longer tread life in high-cycle, hard-floor environments. They are commonly used in food distribution, clean rooms, and facilities where black rubber marks on floors are not acceptable. Polyurethane tires are harder than rubber and may transmit more vibration, so they perform best on smooth, flat surfaces.
20x8x16 Polyurethane Options
Matched Bundle Sets
The 20x8x16 drive tire pairs with the following steer tire sizes in forklift tire bundle sets. Each link leads to a category page for that matched drive and steer combination.
Before Ordering
Confirm your tire size, press-on hub diameter (16"), and drive axle position before placing your order. If you are unsure of your tire size or hub diameter, check the sidewall of your existing tire or your forklift's specifications. Hub diameter is measured across the wheel bore, not the overall wheel width. Incorrect hub diameter will result in a tire that cannot be pressed on or will not seat properly.